The copper used for our copper products is pure Virgin Copper and has been treated with
a clear varnish sealant, which provides extra protection to the patina and to the copper
surface. Yet it is important to remember that even the strongest lacquer cannot take the
place of responsible care and maintenance. Kindly note the maintenance information
below to properly care for your copper products.
CLEANING
• For regular, simple cleaning, use mild NON-ACIDIC liquid detergent or soap and water
and a very soft non-abrasive cotton cloth; other cleaners are not necessary. We
recommend a PH-balanced liquid dish soap such as Ivory, avoiding harsh detergents
such as Dawn/Palmolive, etc.
• For occasional deeper disinfecting, a non-abrasive, non-corrosive cleaner may be used,
such as diluted Simple Green.
• Keep your sink and drain clean and dry by wiping it down and removing all excess
water each time it is used with a soft cloth. After cleaning, be sure to dry the copper hood
thoroughly to prevent water spots and streaks from forming on the surface.
MAINTENANCE
• The copper sinks need to be waxed approximately every 3-6 months depending on the
frequency of use. Beeswax or Honey Wax products such as Flitz Fixture and Faucet Wax
(available online at Flitz.com), are recommended. Apply wax lotion with a soft, clean
cloth and buff with a clean, soft, non-abrasive cloth, referring to wax manufacturer’s
instructions.
• Note: Wax may be applied OVER clean, dry Lacquer finishes regularly to give sinks a
rich look and to protect and extend the life of the lacquer sealant indefinitely.
• SCRATCHES: A surface scratch that penetrates the lacquer can cause the underlying
copper to patina. A light application of KRYLON Clear Sealer can be used over a cleaned,
dry sink to re-seal the scratched surface. Please refer to our Terms or Conditions for
further warranty information regarding finishes.
DO NOT
• Do not use copper polish/cleaners, abrasive materials, acidic or abrasive cleaners
(such as Comet/Soft Scrub) or harsh chemicals such as acetone – these will compromise
the integrity of the Lacquer Finish and can ruin the surface of the copper products.
• Hot pan/pot taken directly from a stove/oven/range should not be placed in copper
sinks. it has to be set and cool down before putting it in the sink.
• Do not leave Acidic foods sitting on the surface of the sink for extended periods.
• Rubber mats may be used [in the bottom of the sink bowls and over the rims] while
cleaning dishes. Remove the rubber mats as soon as possible and do not leave them in
the sink.
NOTE
• As copper is a natural metal, its patina will naturally change slightly with use, over time,
and the copper sink/hoods will develop a warmer, richer patina. The sinks or hoods will
not turn green as the lacquer is protective.
● As all copper products are individually handcrafted and made-to-order, minor